Bathmate Hydroshower

Using the Hydroshower

Before using the Hydroshower, ensure the hydro wand is placed upright in the holder and the flow control is fully depressed in the off position.

Start your shower and select a suitable water temperature. Let the hydro reservoir fill with water until it overflows. Remove the hydro wand from the holder and, holding it with the tip downward, fully open the flow control, allowing the water to flow through the hose and displace any air. Once a steady flow is achieved, double-check that the water temperature is correct and adjust the flow control to the desired level. Check that there is sufficient water in the reservoir for your intended use and refill if necessary. If necessary, the showerhead can be positioned above the reservoir to provide a constant flow.

Installation of the Hydroshower

Care must be taken to ensure the Hydroshower is installed correctly to fully benefit from its advantages. Incorrect installation and/or misuse will not ensure optimal results and may void the warranty.

The Hydroshower contains:

• Adjustable mounting strap
• Mounting bracket/Hydro rod holder
• Hydro reservoir
• Reservoir connector
• Snake
• Current regulator
• Hydro rod connector
• Hydro rod

To install the Hydroshower, first attach the mounting bracket to the Hydro reservoir, noting that the bracket can be reversed to position the hydro wand holder either to the left or right of the reservoir. The bracket will click into place with a positive click, so be careful not to get your finger between the inside of the bracket and the reservoir.

Thread the safety strap through the opening in the bracket. Determine a suitable location for mounting the reservoir in the shower, keeping in mind that the reservoir must be below the showerhead for filling, and that the water flow from the hydro wand nozzle will be greater if the reservoir is placed higher. Adjust the mounting strap as needed.

Attach the hydro rod to the rod connector using the threads, being careful not to overtighten or overlap the threads, and place the hydro rod in the bracket. Attach the reservoir connector to the reservoir mount in the same way.

Feed the hose through the flow control before attaching the reservoir connector and the wand connector. The control can be positioned in either direction and in the most convenient position on the hose. The wand and reservoir connectors are a simple friction fit, and the hose can be pulled in or out as needed. Your Hydroshower is now ready for use.

Cleaning and maintenance

After use, the Hydroshower should be disassembled, washed with warm, soapy water, and rinsed thoroughly. Ensure the flow control is removed and that no water remains in the hose. Let it dry and store it in a dry place out of direct sunlight. Under normal use, the Hydroshower requires no maintenance, but after extended use, you may notice slight discoloration of the transparent hose. This is a natural phenomenon and completely harmless.